Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Ford Festiva L PlusFACTORY OEM SERVICE PROCEDURE
ECA 57 - No Code (Key On Power)
- With key on, check for 12 volts at ECA terminal 3I. If voltage is not present, check for opens or shorts in wiring between ignition switch and ECA. Repair as necessary.
- With ignition switch in "START" position, check for 12 volts at ECA terminal 3I. If 12 volts is not present, check ignition switch for proper operation. Repair or replace as necessary. Go to ECA 59 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.