Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Ford Festiva L PlusFACTORY OEM SERVICE PROCEDURE
ECA 2 - Code 01 (Ignition Pulse)
- Check for loose connectors, corrosion or damage at ignition coil negative terminal and ECA terminal 1M. Repair as necessary.
- With key on and engine off, check voltage at terminal 1M at ECA. Voltage should read 12-14 volts. If voltage reading is correct, replace ECA.
- If voltage reading is incorrect, check for short in White wire from coil negative terminal to terminal 1M of ECA. If symptom still persists, go to ECA 55 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.