1988 Ford Bronco II RWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal & Installation

WARNING: This page is about the Bronco II 4WD, Automatic, which is a different variant/trim than selected.

TRANS ID - A4LD

Applies ToNoteStandard HoursWarranty HoursSkill Level
4WD5.24.1C
Additional Procedure: TRANSMISSION ASSEMBLY: Removal & Installation:
w/Trans Skid Plate add0.20.2C
Combination Procedure: CONVERTER: Drain & Test:
0.50.5C
Combination Procedure: FLYWHEEL: Remove & Replace:
0.30.3C
Combination Procedure: OIL PUMP SEAL: Remove & Replace:
Front0.10.1B
Combination Procedure: TORQUE CONVERTER: Remove & Replace:
0.1C
Combination Procedure: TRANS OIL PUMP: Remove & Replace or Overhaul:
Front0.60.6B
Combination Procedure: TRANS OIL PUMP BUSHINGS & SEAL: Remove & Replace:
0.2B
Combination Procedure: TRANSMISSION ASSEMBLY: Replace:
0.6C
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.