Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Ford Bronco II 4WD, Standard, M5OD-R1FACTORY OEM SERVICE PROCEDURE
Timing Check
- Turn key off, wait 10 seconds. Start engine. Activate KEY ON ENGINE RUNNING (KOER) SELF-TEST . After the last service code has been displayed, the timing will remain fixed for 2 minutes, unless SELF-TEST is deactivated.
- Correct SELF-TEST timing equals base ignition timing (10 degrees BTDC on all engines) plus 17-23 degrees BTDC. If timing is not 27-33 degrees BTDC, go to TEST D13 . If timing is 27-33 degrees BTDC, proceed with KEY ON ENGINE RUNNING (KOER) SELF-TEST.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.