Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Selector Valve: Description
Systems usually consist of a fuel selector switch, fuel pump relay (some models), tank selector valve, inertia switch (some models) and fuel pump. Tank selector valves may contain a different amount of ports depending upon application. See Figure .
Some Ford Motor Co. models with Electronic Fuel Injection (EFI) may contain a dual function reservoir in place of the 6-port valve. See Figure . This alters fuel delivery by fuel pressure placed on a diaphragm. The reservoir is not electrically controlled.
Some Ford Motor Co 7.5L models may contain a Hot Fuel Handling system. This system uses 2 electric fuel pumps in the fuel tank and fuel pump cut-off relay. On 7.5L models without Hot Fuel Handling, electric fuel pumps and cut-off relay are not used. See Figure and Figure . These systems contain different components and test procedures.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.