Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Ford Tempo LX, 4D Sedan, 2.3 X, AutomaticFACTORY OEM SERVICE PROCEDURE
Code Output
- Deactivate SELF-TEST (disconnect jumper wire). Start engine and run it at 2000 RPM for 2 minutes to warm up HEGO sensor. Turn engine off and wait 10 seconds
- Start engine. Insert jumper to activate SELF-TEST. The engine ID code will be displayed. On vehicles equipped with the 2.3L HSC/CFI engine, the steering wheel MUST be turned one-half a turn and released AFTER the ID code.
- If a Dynamic Response code occurs, briefly accelerate engine to wide open throttle (WOT). DO NOT depress throttle during test unless a Dynamic Response code occurs. The KEY ON/ENGINE RUNNING (KOER) SELF-TEST service codes will then be displayed. Observe and record all codes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.