Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Ford Taurus L4-153 2.5L HSCFACTORY OEM SERVICE PROCEDURE
Rear
| <Sedan> | <Wagon> | ||
| <Rear> | Camber Angle | -1 5/8 to - 1/4 Degrees (deg) | -1 5/16 to 1/16 Degrees (deg) |
| Camber Angle Desired | - 15/16 Degrees (deg) | - 5/8 Degrees (deg) | |
| Toe | 1/16 Inch (in) | 1/16 Inch (in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.