Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Ford Taurus L4-153 2.5L HSCFACTORY OEM SERVICE PROCEDURE
Electronic Automatic Temperature Control System
Fig. 15 Control panel removal:
1. Disconnect battery ground cable.
2. Pull out lower instrument panel snap-on inserts from both sides, then remove upper finish panel attaching screws, Fig. 15.
3. Pull lower edge of upper finish panel away from instrument panel.
4. Remove four Torx screws from control head.
5. Pull control head away from instrument panel, then disconnect two harness connectors from head assembly.
6. Remove vacuum harness retaining nuts, then separate control panel from instrument panel.
7. Reverse procedure to install.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.