Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Ford Escort GTFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS (1)
| Application | Specification | |||||
|---|---|---|---|---|---|---|
| Caster (Degrees) | (2) + 2 7/16 +/- 3/4 | |||||
| Camber (Degrees) | ||||||
| Left | (2) + 1 3/8 +/- 3/2 | |||||
| Right | + 15/16 +/- 3/4 | |||||
| Toe-in (Inches) | ||||||
| Front | 1/16 +/- 1/32 | |||||
| Rear | 3/16 +/- 3/16 | |||||
| Toe-Out on Turns (Degrees) | ||||||
| Inner | 20 | |||||
| Outer | 18.2 | |||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.