Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Ford Mustang SVOFACTORY OEM SERVICE PROCEDURE
Test SS - System Check
- ISC Check. Attempt to start engine at part throttle. If engine runs only at part throttle, go to TEST Z - BY-PASS AIRΒ , step 3). If engine does not run, go to step 3).
- EGR Check. Disconnect and plug vacuum hose at EGR valve. Ensure that EGR valve is closed. Attempt to start vehicle.
- If vehicle runs, go to TEST W - EGR ON/OFF CHECKΒ , step 1) for all 1.9L EFI and 2.3L EFI/Turbo models.
- If vehicle does not run, go to TEST Q - FUEL CONTROL, step 1) for all 1.9L EFI & 2.3L EFI/Turbo models.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
