1985 Ford Ranger 2.0 CFACTORY OEM SERVICE PROCEDURE

Reminder Light Reset Procedure

  1. Turn ignition off. Insert Phillips screwdriver into hole in timer unit. While pressing screwdriver in, turn ignition to "RUN" position.
  2. Light should be on. Hold screwdriver in for 5 seconds. Remove screwdriver. Light should go out in 2-10 seconds. If not repeat steps 1) and 2).
  3. Turn ignition off. Turn ignition to "RUN" position. Light should come on for 2-10 seconds. This verifies proper reset of light module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.