Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Ford Ranger 2.2 PFACTORY OEM SERVICE PROCEDURE
Output State Not Functioning Test
- Turn ignition off and wait 10 seconds. Perform Key On - Engine Off Test. Leave ignition on to enter output state check. Check for codes 23, 53, 63 and/or 68 during the On Demand Test results. If any of the codes are displayed, service as necessary according to the On Demand instructions of the Key On - Engine Off Test. If none of the listed codes are displayed, leave ignition on and proceed with test.
- Connect voltmeter negative lead to self-test output connector and positive lead to battery positive post. Depress throttle wide open and release. Apply slight pressure to throttle lever. Measure voltage. If voltage is 10 volts or less, replace TP sensor and repeat Quick Test. If voltage is more than 10 volts, check throttle linkages for sticking or binding, repair as necessary, and repeat Quick Test.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
