Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Ford EXP Base, 1.6 2FACTORY OEM SERVICE PROCEDURE
Key On/Engine Running (KOER) Test
- Disconnect grounded jumper wire from self test input. Start engine and run at 2000 RPM for 2 minutes.NOTE: If engine will not start, perform No Start Test.
- Restart engine and run at idle. Reconnect grounded jumper wire to self test input. Code 20 will be displayed and followed within 60 seconds by the service codes. Observe and record service codes until code 10 is displayed. If engine stalls while testing, perform Symptom Diagnosis Test. If more than 1 code is displayed, correct problems in order that codes were received. Repair codes as follows:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
