1978 Ford FiestaFACTORY OEM SERVICE PROCEDURE

Ignition Coil Test

With ignition off, check secondary resistance between Red wire (pin No. 4) and coil tower. Resistance should be 7000-13, 000 ohms. Check primary resistance between Green wire (pin No. 1) and Blue wire (pin No. 6). Resistance should be 1-2 ohms. If resistance is within limits but the coil is still suspected, test coil on a standard coil tester. If reading differs from the original test, check for a defective harness.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.