1977 Ford Bronco Automatic TransFACTORY OEM SERVICE PROCEDURE

MOTORCRAFT DURA-Spark II Ignition System: Overhaul: Distributor: Disassembly

  1. Remove distributor cap and rotor. Disconnect distributor harness plug. Using a small gear puller or 2 screwdrivers, lift or pry armature from advance plate sleeve and remove roll pin. Remove wire retaining clip, then remove snap ring securing vacuum advance link to pick-up assembly.
  2. Remove pick-up assembly retaining screws and lift assembly from distributor. Lift vacuum advance arm from pick-up assembly and position against distributor housing. Remove vacuum advance diaphragm unit. Remove attaching screws and lift base plate assembly from distributor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.