Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1976 Ford Courier Automatic TransFACTORY OEM SERVICE PROCEDURE
1976-78 Models
- Every 12, 500 miles the EGR warning lamp on instrument panel will come on. When lamp comes on, the EGR valve should be inspected and tested, after servicing EGR system, the EGR warning lamp switch should be reset.
- To reset switch, remove EGR switch cover. Switch is located behind speedometer. Slide switch knob in the opposite direction and the lamp will go out. Every 25, 000 miles, the EGR valve should be removed and cleaned.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
