1971 Ford P-100FACTORY OEM SERVICE PROCEDURE

Automatic Transmission

Start engine, apply foot brake and move shift lever through all positions. The light should only go out in Reverse position. If light stays on in all positions, circuit is grounded or switch is faulty. If light does not go on at all, circuit is open or switch is faulty. Repair or replace switch as necessary and reconnect switch lead to valve.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.