Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Systems - Solid State Ignition: Overhaul: Disassembly
Remove distributor cap and rotor. Disconnect distributor harness plug. Using a small gear puller or two screwdrivers, lift or pry armature from advance plate sleeve and remove roll pin. Remove wire retaining clip, then remove snap ring securing vacuum advance link to pickup assembly. Remove pickup assembly retaining screws and lift assembly from distributor. Lift vacuum advance arm from pickup assembly and position against distributor housing. Remove vacuum advance diaphragm unit. Remove attaching screws and lift base plate assembly from distributor.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
