1971 Ford P-100FACTORY OEM SERVICE PROCEDURE

Description & Operation: Notes

Solid State Ignition system uses an electronic module to control system, a breakerless distributor and an oil filled coil. When ignition switch is on, primary circuit is on and ignition coil is energized. As distributor shaft rotates, the distributor generates signals causing module to break the primary current and induce secondary voltage in coil. A timing circuit in module turns primary circuit on again to energize coil for next spark cycle. The dwell varies with engine speed and cannot be altered, so any measurement is unnecessary.

Fig 1: PRIMARY CIRCUIT WIRING
G09325454Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.