1971 Ford P-100FACTORY OEM SERVICE PROCEDURE

Starting Circuit Test

Voltage between pin #5 and engine ground with engine cranking should read between 8 and 12 volts. If reading not within limits, the ignition by-pass circuit is open or grounded from either the starter solenoid, the ignition switch to pin #5 or primary connections at the coil. Repair or replace as necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.