1971 Ford P-100FACTORY OEM SERVICE PROCEDURE

Vacuum Retard

Readjust engine idle speed to 550-600 RPM. Using a timing light observe timing. Remove plug from manifold vacuum line and connect line to inner diaphragm. Timing should retard immediately. Replace dual diaphragm unit if either of the diaphragms are leaking or if the retard portion is out of calibration. Replacement is also called for if the advance portion cannot be calibrated to specifications. See "Ford Motor Co. Vacuum Advance & Retard Specifications" in IGNITION DISTRIBUTORS Section.Β 

Fig 1: DUAL DIAPHRAGM DISTRIBUTOR ADVANCE MECHANISM
G09325331Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.