Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Standard Procedure - Hoisting
In the event that it becomes necessary to raise the car, go to a Jeep Dealership, which is equipped with surface lift or equivalent.
The points for lifting the vehicle using the lift are marked on the side skirts with the symbols shown in the illustration.
Be careful to select the lift pads sized to fit to the underbody of the car. Also, make sure to correctly place the pads themselves at the openings indicated on the sill cladding. These openings are not necessarily aligned with the triangle markings, which are specifically related to the recommended location for the emergency jack, provided with the vehicle.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
