Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Fiat 500X PopFACTORY OEM SERVICE PROCEDURE
Removal And Installation
REMOVAL
- Disconnect and isolate the negative battery cable.
- Remove the ignition coils. Refer to COIL, IGNITION, REMOVAL AND INSTALLATION .NOTE:
Prior to loosening the spark plug, use compressed air to blow out any debris that might be in the spark plug tube.
- Using the appropriate socket, remove the spark plugs (1) from the cylinder head.
INSTALLATION
- Install the spark plug to the cylinder head and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the ignition coils. Refer to COIL, IGNITION, REMOVAL AND INSTALLATION .
- Connect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.