2018 Fiat 500L LoungeFACTORY OEM SERVICE PROCEDURE

Active Restraints

The active restraints for this vehicle include:

  • Child Restraint Anchors  - All vehicles are equipped with three, fixed-position, child seat upper tether anchors for the rear seating. A single upper tether anchor is integral to the back of the left seat cushion frame, and two anchors are integral to the back of the right seat cushion frame. Two lower anchors are also provided for each outboard rear seating position. The lower anchors are integral to the seat cushion frames as well. All lower anchors are accessed from the front of the rear seat near where the seat back meets the seat cushion.
  • Front Seat Belts  - Both front seating positions are equipped with three-point seat belt systems employing a lower B-pillar mounted inertia latch-type emergency locking retractor, fixed upper B-pillar mounted turning loops, a fixed lower seat belt anchor buckle secured to a latch plate on the inner sill near the base of the B-pillar and a traveling end-release seat belt buckle secured to the inboard side of the upper inner seat adjuster track. The driver and passenger side front seat belt buckles each include an integral seat belt switch that detects whether the front seat belts have been fastened.
  • Rear Seat Belts  - All three rear seating positions are equipped with three-point seat belt systems. The outboard belts employ C-pillar mounted inertia latch-type emergency locking retractors, fixed position upper C-pillar mounted turning loops and fixed lower seat belt anchors secured to the quarter inner panel. The center belt employs an inertia latch-type emergency locking retractor secured within the right seat back and a fixed lower anchor secured to the seat cushion frame. The fixed end release rear seat belt buckles are secured to the rear seat cushion frames.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.