Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Fiat 500L LoungeFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Accelerator Pedal Retaining Bracket Nuts | 12 | 9 | - |
| Inlet Air Temperature/Manifold Air Pressure (IAT/MAP) Sensor Bolt | 9 | - | 80 |
| Oxygen Sensor | 45 | 33 | - |
| Crankshaft Position (CKP) Sensor Bolt | 4 | - | 35 |
| Crankshaft Position Sensor Shield Bolt | 9 | - | 80 |
| Crankshaft Position Sensor Shield Nut | 9 | - | 80 |
| Negative Battery Cable Nut | 5 | - | 45 |
| Throttle Body Bolts | 9 | - | 80 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.