2017 Fiat 500L LoungeFACTORY OEM SERVICE PROCEDURE

Sensor, Coolant Temperature: Installation

GC0152369Courtesy of CHRYSLER GROUP, LLC
  1. Install the engine coolant temperature sensor (4) into the thermostat housing.
  2. Connect the wire harness connector.
    GC0152380Courtesy of CHRYSLER GROUP, LLC
  3. Install the battery (4) and the hold down clamp. Tighten the nut to 55 Nm (40 lbf-ft).
  4. Install the air intake assembly.
  5. Fill the cooling system. Refer to STANDARD PROCEDUREΒ .
  6. Connect the positive and negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.