Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radiator, Engine Cooling: Removal
The radiator (3) will need to be removed from the vehicle along with the air-conditioning condenser (1) and intercooler (2) as an assembly (cooling module). Once removed, the radiator fan can be removed from the cooling module.
- Disconnect the battery negative cable.
- Remove the engine cover (3).
- Drain the cooling system. Refer to STANDARD PROCEDUREΒ .
- Remove the coolant bottle bolts (2), set the bottle (1) aside.
- Disconnect the upper radiator hose from the radiator.
- Disengage the hose retainers (2).
- Unplug the fan connector (6).
- Unplug the fan resistor (1).
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Disconnect the lower radiator hose from the radiator.
- Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
- Remove the headlights
- Remove the FEM upper bolts (3) and remove the bumper.
- Disengage the hood latch cable.
- Remove the harness from the loom (2).
- Remove the manifold bolt, separate the lines and remove the gasket. Discard the gasket.
- Tape over or cap the condenser and lines.
- Remove the two bolts (1) at the line support bracket.
- Remove the shroud bolts (2). Pinch the upper mounts (1) and remove the shroud (3).
- Disconnect the CAC inlet at the quick connect (1).
- Disconnect the CAC outlet (3) at the quick connect (1).
- Remove the upper cooling fan mounting bolts (3).
- Lift the cooling module up and off of the lower supports by clearing the lower pins (4) from the mounts.
- Remove the fan mount bolt.
- Compress the catches inward (1 and 2) to allow the fan to be slid out of the mounts.
- Slide the fan to the left to clear the right side mounts.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
