Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Fiat 500L LoungeFACTORY OEM SERVICE PROCEDURE
Module, Electronic Shift (ESM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| P0560-16 | BATTERY VOLTAGE - CIRCUIT VOLTAGE BELOW THRESHOLD |
| P0560-17 | BATTERY VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| P0607-29 | ECU INTERNAL PERFORMANCE - SIGNAL INVALID |
| P0607-44 | ECU INTERNAL PERFORMANCE - DATA MEMORY FAILURE |
| P0607-45 | ECU INTERNAL PERFORMANCE - PROGRAM MEMORY FAILURE |
| P0607-48 | ECU INTERNAL PERFORMANCE - SUPERVISION SOFTWARE FAILURE |
| P081C-14 | PARKING SWITCH - CIRCUIT SHORT TO GROUND OR OPEN |
| P081C-24 | PARKING SWITCH - SIGNAL STUCK HIGH |
| P0915-81 | LIGHT FAULT ON SHIFT LEVER (YELLOW FLAG) - INVALID SERIAL DATA RECEIVED |
| P0917-81 | HEAVY FAULT ON SHIFT LEVER (RED FLAG) - INVALID SERIAL DATA RECEIVED |
| P0929-01 | SHIFT LOCK COIL - GENERAL ELECTRICAL FAILURE |
| P0929-1C | SHIFT LOCK COIL - CIRCUIT VOLTAGE OUT OF RANGE |
| P1C86-11 | MASK LEVER FAIL - CIRCUIT SHORT TO GROUND |
| P1C86-15 | MASK LEVER FAIL - CIRCUIT SHORT TO BATTERY OR OPEN |
| P2924-81 | TIP POSITION SENSORS - INVALID SERIAL DATA RECEIVED |
| PC001-87 | GEARBOX SELECTOR MODULE CAN LINE - NODO MUTE |
| PC001-88 | GEARBOX SELECTOR MODULE CAN LINE - BUS OFF |
| PD700-86 | BODY CONTROL MODULE CAN LINE - SIGNAL INVALID |
| PD700-87 | BODY CONTROL MODULE CAN LINE - MISSING MESSAGE |
| PD701-87 | ENGINE CONTROL MODULE CAN LINE - MISSING MESSAGE |
| PD711-86 | DUAL CLUTCH TRANSMISSION MODULE CAN NODE - SIGNAL INVALID |
| PD711-87 | DUAL CLUTCH TRANSMISSION MODULE CAN NODE - MISSING MESSAGE |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.