Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Restraints (Service Information): Warning
- SAFETY INSTRUCTIONS TO BE FOLLOWED FOR OPERATIONS ON CARS EQUIPPED WITH AIRBAG SYSTEMS NOTE:
The following instructions MUST BE FOLLOWED for any operation involving cars equipped with Air Bag safety systems.
Preliminary instructions
NOTE:Remember that Air Bag modules must be handled with care. Their use, transportation and storage are regulated by the procedures for handling such components, which are given below.
Before carrying out any repair operations on the bodywork, welding or operations that involve removing the AirBag modules or the AirBag control unit:
Go to Key-OFF condition.
Always disconnect the battery, i.e. disconnect the two terminals (positive and negative) from their poles and carefully insulate them with tape.
Wait for at least one minute before disconnecting the electrical connections of the airbag system components.
Position the devices with the cover upwards in a locked metal cupboard. This cupboard, intended exclusively for this purpose, must not, under any circumstances, be used to store any other types of material, particularly if they are flammable. The cupboard must be designed to store pyrotechnic charges (metal, impact resistant cupboard with grates to allow natural internal ventilation) and must have the markings required by law (DANGER PYROTECHNICS - NO OPEN FLAMES - NOT TO BE OPENED BY UNAUTHORIZED PERSONNEL).
NOTE:The continuity of the system components can only be measured after the modules have been replaced with specific dummy resistances.
A system component that has not been activated during an accident is considered to still be "active". Therefore, non-deployed pyrotechnic components that have to be removed from the vehicle (for defects, if the warranty has expired, or other reasons) should be returned to the appropriate center following the procedure described below.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
