Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Program The Pcm (Powertrain Control Module)
This procedure is required when one or more of the following situations are true:
- A Powertrain Control Module (PCM) has been replaced.
- Diagnostic Trouble Code (DTC) P1602 - PCM Not Programmed is set.
- An updated calibration or software release is available for either the PCM or Transmission Control Module (TCM).
This procedure assumes that the scan tool is properly configured to the dealership network with either a wired or wireless connection. For help on how to network the scan tool, use the "Help" tab at the top of the diagnostic application.
Perform the following steps and/or routines to program the PCM:Â
Check PCM VINÂ
From the "Home" screen, select "ECU View"
- Select "PCM"
- Select "Misc. Functions"
- Select "Check PCM VIN" and follow the on screen instructions.
- When complete, select "Finish"
Transmission Self LearningÂ
Ignition OFF for 10 seconds to perform a Power latch of module. Turn ignition on.
- Automatic Transmission a vehicle is learned on first key ON
- Manual Transmission vehicles depress clutch switch fully.
- Check DTCs. DTC P1302 should go stored
Cruise control learnÂ
Start engine
- Press and hold the Cruise ON/OFF switch for 3 to 10 seconds or till the cruise light illuminates.
Clear Misfire TLC routineÂ
From the "Home" screen, select "ECU View"
- Select "PCM"
- Select "Misc. Functions"
- Select "Clear Misfire TLC" and follow the on screen instructions.
- When complete, select "Monitors" tab at top of screen
- Select "OBD II Monitors"
- Select "Mis-Fire MON SCW"
- Verify coolant temperature is above 60°C (140°F)
- Observe the Misfire Monitor Status
- Perform 6000 RPM WOT and let engine return to idle
- Status will change from
waitingÂ
to
in progressÂ
- In ProgressÂ
Verifies misfire is active and service is complete
Throttle Body Self LearnÂ
From the "Home" screen, select "ECU View"
- Select "PCM"
- Select "Misc. Functions"
- Select "Throttle Body Self Learn" and follow the on screen instructions.
- When complete, select "Finish"
Check PCM OdometerÂ
From the "Home" screen, select "ECU View"
- Select "PCM"
- Select "Misc. Functions"
- Select "Check PCM Odometer" and follow the on screen instructions.
- When complete, select "Finish".
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
