Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Fiat 500L Easy, Automatic TransFACTORY OEM SERVICE PROCEDURE
Module Programming Module Electric Power Steering
PERFORMING EPS STEERING ANGLE CALIBRATION PROCEDURE
- Using the scan tool, under "Miscellaneous Functions" perform the STEERING ANGLE CALIBRATION procedure in the EPS Module.
- With the scan tool, select View DTCs in the EPS Module.
Are there any DTCs present?
Yes
- Perform the appropriate diagnostic procedure(s). Refer to DIAGNOSIS AND TESTING .
No
- Test Complete
- Perform the EPS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
