Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Fiat 500L Easy, Automatic TransFACTORY OEM SERVICE PROCEDURE
Configure Door Lock Routine
NOTE:
If the Body Control Module (BCM) is being replaced with a new unit, a diagnostic scan tool MUST be used to run the Configure Door Locks routine
- Select the BCM module from the "Vehicle View" screen
- Select the Misc. Functions tab with the "BCM View" menu options
- Select the Configure Door Lock routine and click the start button
- Follow the prompts on the screen to complete the procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
