Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Fiat 500eFACTORY OEM SERVICE PROCEDURE
Resolver Relearn
- Position the vehicle on a hoist, and raise the vehicle until the front tires are approximately 30 cm. (12 in.) from the ground. Refer to HOISTING .
- Connect the scan tool to the diagnostics connector.
- Enter the vehicle and make sure the vehicle doors are closed to prevent the Automatic Shift to Park function from engaging during the test.
- Turn off the Electronic Stability Control (ESC) button on the instrument panel.
- Using the scan tool, switch the vehicle to READY mode.
- Perform the Resolver Relearn procedure by following the step-by-step instructions on the scan tool.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.