2013 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE

Aw60T Transmission Verification Test

For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS article  .

    1. Perform the following after completion of a diagnostic repair:
      1. Reconnect any disconnected components.
      2. Connect the scan tool to the Data Link Connector (DLC).
      3. With the scan tool, erase all Transmission and Engine DTCs.
      4. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
      5. Check the Transmission fluid level and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
      6. With the scan tool, perform the TCM Quick learn procedure if a transmission component has been replaced, or the TCM has been replaced or flashed. Perform AW60T TCM Quick Learn.
      7. Road test the vehicle allowing the vehicle to shift through all gears.
      8. Check for DTCs during and after the road test.

      Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

      Yes 

      No 

      • Repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.