Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Fiat 500c Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE
Module, Electronic Power Steering (EPS)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| C1001-49 | EPS - INTERNAL ELECTRONIC FAIILURE |
| C1002-17 | TORQUE SENSORS 1 AND 2 - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| C1002-1C | TORQUE POSITION SENSOR-CIRCUIT VOLTAGE OUT OF RANGE |
| C1003-86 | VEHICLE SPEED SIGNAL INVALID |
| C1005-86 | STATUS LAMP FAILURE BCM - SIGNAL INVALID |
| C1008-54 | EOL SENSOR POSITION TRIM-MISSING CALIBRATION |
| C1009-54 | EOL TORQUE TRIM-MISSING CALIBRATION |
| C1200-16 | BATTERY VOLTAGE - BELOW TRESHOLD |
| C1200-17 | BATTERY VOLTAGE - ABOVE THRESHOLD |
| C1214-55 | EOL VEHICLE CONFIGURATION - NOT CONFIGURED |
| U0001-87 | CAN C BUS - NO SIGNAL |
| U0001-88 | CAN C BUS OFF |
| U1700-86 | IMPLAUSIBLE DATA RECEIVED FROM BCM |
| U1700-87 | LOST COMMUNICATION WITH BCM |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.