2012 Fiat 500c Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM)

Fig 1: Body Control Module (BCM)
GC0153215Courtesy of CHRYSLER GROUP, LLC

The Body Control Module (BCM) (1) is located under the driver side of the instrument panel behind the hood latch release.

The BCM integrates an electromechanical section for power distribution and an electronic management section for the control of body electrical functions and vehicle communications. The BCM includes a double row of fuses for circuit protection single-terminal battery power connector.

The BCM integrates a series of built-in relays to operate body electrical circuits, such as low beams, power windows, central locking, front and rear windshield wipers, and interior lights. The BCM internal relays are mounted to the printed circuit board and are not serviceable. In addition, the BCM contains high-side drivers and low-side drivers to control and protect circuits with low inductive loads.

For information on fuse description. Refer to FUSE LOCATIONS AND TYPES, SPECIFICATIONS .

For more information about the BCM. Refer to MODULE, BODY CONTROL, DESCRIPTION .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.