2012 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE

Diagnostic Test

  1. VERIFY THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE 
    NOTE:

    Make sure the battery is fully charged before proceeding.

    1. Turn the ignition on.
    2. With the scan tool, read the active DTCs.

      Does the scan tool display: U0140-LOST COMMUNICATION WITH BODY CONTROL MODULE?

      Yes 

      • Refer to  DIAGNOSIS AND TESTING  and perform the NO RESPONSE FROM BCM (BODY CONTROL MODULE) diagnostic procedure.

      No 

      • Refer to  DIAGNOSIS AND TESTING  and perform the Stored Lost Communication DTCs diagnostic procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.