2012 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE

Standard Procedure - Column Relearn

NOTE:

If the Electric Power Steering (EPS) column has been replaced, the following steps must be performed to ensure that the column is functioning correctly.

  1. Perform the Vehicle Trim Procedure. Refer to STANDARD PROCEDURE .
  2. Set the parking brake and start the engine.
  3. Place the transmission in Neutral.
  4. Starting with the steering wheel in the straight ahead position, turn the wheel in the following manner:
    1. All the way to the left until it stops.
    2. All the way to the right until it stops.
    3. All the way to the left until it stops.
    4. All the way to the right until it stops.
    5. Return the wheel to the straight ahead position.
  5. Verify that the steering assist works smoothly, with no hard points and/or sudden variation.
  6. Verify that the EPS warning light is not illuminated.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.