Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE
Switch, Ignition: Installation: Installation
- Install the ignition switch.
- Tighten the special new bolts until the heads shear off.
- Connect the electrical connection for the ignition switch.
- Install the aerial antenna ring.
- Connect the aerial antenna electrical connector.
- Install the steering column trim. Refer to SHROUD, STEERING COLUMN, LOWER, INSTALLATION and SHROUD, STEERING COLUMN, UPPER, INSTALLATION .
- Connect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.