Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fan, Cooling: Installation: Installation
Fig 1: Lower Radiator Support Brackets, Radiator Mount, Lower Cooling Module Support & Mounting Bracket Bolt
- Guide the cooling fan into position onto the radiator tabs through the bottom of the vehicle.
- Position the radiator into place and install the lower radiator support bracket (2) to the radiator mount (5). Tighten mounting bracket bolt (3) to 8 N.M (70 in.lbs.).
- Install the upper (4) and lower (3) air seals.
- Install the from bumper support beam (1). Tighten mounting bolt to 40 N.M (30 ft.lbs.).
- Install the front bumper facia. Refer to FASCIA, FRONT, INSTALLATION .
- Lower vehicle.
- Install the upper mounting screws (4) for the cooling fan. Tighten mounting bolt to 8 N.M (70 in.lbs.).
- Install the wire harness connectors (3) to the cooling fan.
- Connect the resistor (1) harness connector at the cooling fan (2).
- Install the engine cover and air intake assembly.
- Reconnect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
