2012 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE

Vehicle Tracking Module (VTM)

Fig 1: Instrument Panel Cover
GC0153551Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the instrument panel cover (1). Refer to COVER, INSTRUMENT PANEL, REMOVAL .
    Fig 2: Vehicle Tracking Module (VTM) Nut, VTM Bracket Retainer, VTM Electrical Connector & VTM
    GC0153523Courtesy of CHRYSLER GROUP, LLC
  3. Remove the Vehicle Tracking Module (VTM) nut (1) to evaporator.
  4. Remove the VTM bracket retainer (2) to the instrument panel support brace.
  5. Rotate the VTM to disconnect the VTM electrical connector (3).
  6. Remove the VTM (4) from the vehicle.
    Fig 3: VTM & Mounting Bracket Retainers
    GC0153522Courtesy of CHRYSLER GROUP, LLC
  7. Remove the VTM (1) mounting bracket retainers (2) and separate the VTM from the bracket.
NOTE:

If replacing the VTM BACKUP BATTERY or the SUBSCRIBER IDENTIFICATION MODULE (SIM) CARD. Refer to BACKUP BATTERYΒ  or SUBSCRIBER IDENTIFICATION MODULE (SIM) CARDΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.