2012 Fiat 500 Pop, Automatic TransFACTORY OEM SERVICE PROCEDURE

Subscriber Identification Module (Sim) Card

Fig 1: Vehicle Tracking Module (VTM)
GC0153564Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the Vehicle Tracking Module (VTM) (1) from the vehicle. Refer to MODULE, VEHICLE TRACKING, REMOVALΒ .
    Fig 2: Backup Battery
    GC0153514Courtesy of CHRYSLER GROUP, LLC
  3. Remove the backup battery (1). Refer to BACKUP BATTERYΒ .
    Fig 3: SIM Card Holder
    GC0153572Courtesy of CHRYSLER GROUP, LLC
  4. Slide the SIM card holder (1) forward to unlock.
    Fig 4: SIM Card & VTM SIM Card Holder
    GC0153525Courtesy of CHRYSLER GROUP, LLC
  5. Pull the SIM card (2) out of the VTM SIM card holder (1).
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.