1982 Fiat X1/9FACTORY OEM SERVICE PROCEDURE

All Other Models

  1. Turn ignition switch "OFF", and disconnect harness connector from control module. Set ohmmeter to x100 scale. Connect ohmmeter leads to terminals 7 and 31d of harness connector. See Figure. Measure pick-up coil resistance.
  2. If resistance readings are not to specifications, remove connector from distributor, and take reading at pick-up coil pins at distributor.
  3. If readings are still not to specifications, replace pick-up coil. If correct readings are obtained at distributor, but not at harness connector, replace harness.
    PICK-UP COIL RESISTANCE SPECIFICATIONS

    Application Ohms
    BMW 520-700
    Fiat 890-1285
    Mercedes-Benz 500-700
    Porsche 928 485-700
    Volvo
      GLT Turbo 4-Cylinder 950-1250
      GLE V6 540-660
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.