1982 Fiat X1/9 L4-1498cc 1.5LFACTORY OEM SERVICE PROCEDURE

High Altitude Emissions - Modifications

S.L. 000-51

DATE: 7-15-82

SUBJECT:
HIGH ALTITUDE VEHICLES

VEHICLES:
ALL 1982 FIAT MODELS

NOTE:
Vehicles to be sold for principal use at a location above 4,000 feet are considered High Altitude Vehicles. These vehicles must be modified prior to first retail sale by the Dealer in order to meet high altitude emission standards.

MODIFICATION INSTRUCTIONS:

Modification of a vehicle set up for high altitude consists of connecting a special connector. Some Stradas are not set up for high altitude and will require additional modifications as described on the attached sheet.

To modify a vehicle set up for high altitude for operation at high altitude, perform the following:

1. Remove the fuel injection electronic control unit (E.C.U.). Check that the Bosch Part No. (on a self-adhesive label)is:

MODEL BOSCH PART NO. FMNA PART NO.

Spider 0.280.000.201 4429200
X1/9 0.280.000.208 5934558
Strada 0.280.000.208 5934558

If Bosch Part No. is not correct, remove ECU and replace it with correct Part No. unit. Correct units are available from your Parts & Accessory
Distribution Center.

Factory service manual diagram



2. Locate the two connectors on the wire harness to the control unit. Connect these together.

3. Check and adjust idle speed according to the engine compartment emission label.

Factory service manual diagram



4. Affix the vehicle emission control information update label (print No. 3060) next to the emission control label in the engine compartment.

STATEMENT:
This operation will be performed at FMNA expense prior to the first retail sale. Additional changes during the lifetime of the vehicle will be at the vehicle Owner's expense.

To adjust the vehicle after modification for low altitude operation:

^ disconnect the jumper connectors,
^ recheck idle speed,
^ remove the update label.

PARTS INFORMATION:

Attached is a sheet of the Emission Control Information Update Labels, print No. 3060. Additional sheets of the labels are available free-of-charge from your Parts and Accessories Distribution Center.

For Stradas which require the additional modification, a kit, Part No. 000-51 is available from your Parts and Accessories Distribution Center.

WARRANTY INFORMATION:

To claim reimbursement for performing the High Altitude Modification submit a Warranty Claim using the following labor operations and Malfunction Code:


LABOR TIME
OPERATION DESCRIPTION SPIDER X1/9 STRADA

900-00-11 Modify vehicle for .20 .40 .30
high altitude

900-00-12 With A.C. .30 ^ ^

900-00-13 Install High ^ ^ .70
Altitude Kit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.