1975 Fiat SpiderFACTORY OEM SERVICE PROCEDURE

Stall (Lock) Test

With starter mounted in test stand and ring gear locked, adjust test stand rheostat to values specified (see specifications) and observe torque on dial indicator.

STARTER PERFORMANCE SPECIFICATIONS

Model No Load Test(1) Lock Test
Amps. RPM Amps. Volts Torque (Ft. Lbs.)
E 84-0.8/12 Below 35 7000 ±500 370 8.3±0.3 7.9±.36
E 100-1.3/12 Below 28 5200±500 530 7±0.3 12.58±.7
(1) At 12 volts.
Fig 1: Performance Test Wiring Diagram
G09350281Courtesy of NOT AVAILABLE
CRANKING AMPERAGE DRAW

Starter No. Amps @ RPM Torque (Ft. Lbs.)
E 84-0.8/12 170@1950±100(1) 2.89±.14
E 100-1.3/12 280@1600±100(2) 5.87±.14
(1) At 10.3 volts.
(2) At 9.5 volts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.