1974 Fiat SpiderFACTORY OEM SERVICE PROCEDURE

Charging Systems: Alternators: Description

Fiat alternators are conventional three-phase, self-rectifying type alternators. Six silicon rectifier diodes are connected to form a full-wave, three-phase rectifying bridge. The three negative rectifier diodes (identified by black wording) are pressed directly in the end frame. Three positive diodes (identified by red wording) are located in a heat sink which is insulated from the end frame.

Fig 1: Charging With Indicator Light (One Pole Grounded)
G09349561Courtesy of NOT AVAILABLE
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.