Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Test TC-86B: Speed Control Switch Always High
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATIONΒ . For wiring diagram, see WIRING DIAGRAMS article.
- Condition to set trouble code is not present at this time. SPEED CONTROL SWITCH ALWAYS HIGH DTC sets if an open condition is detected in speed control ON/OFF switch circuit. Possible causes are: multiplexing switch(es) (speed control switches) shorted to power, multiplexing switch(es) (speed control switches) open, ON/OFF switch open or Powertrain Control Module (PCM) failure. Go to next step.
- Observe scan tool speed control switch voltage. Wiggle wiring harness between speed control ON/OFF switch and Powertrain Control Module (PCM). If voltage was more than 4.9 volts at any time, repair wiring harness as necessary where wiggling caused problem to appear. Perform TEST VER-4AΒ . If voltage was not more than 4.9 volts at any time, problem is not present at this time. Test is complete. Perform TEST VER-4AΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
