Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Test TC-21A: Injector Control Circuit
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS article.
- Start engine. Allow engine to idle for at least 20 seconds. Using scan tool, read Diagnostic Trouble Codes (DTCs). If scan tool displays any INJECTOR CONTROL CIRCUIT codes with a run/start count of zero, go to step 5) . If scan tool does not display any INJECTOR CONTROL CIRCUIT codes with a run/start count of zero, go to next step.
- Condition to set trouble code is not present at this time. INJECTOR CONTROL CIRCUIT DTC sets if no inductive kick is sensed .18 milliseconds after injector turn off with no other injectors on. This DTC takes .64-10 seconds to set. Possible causes are: open or shorted injector driver circuit, open injector, open ASD supply voltage at injector, Powertrain Control Failure (PCM) failure, faulty connections or wiring. Go to next step.
- Inspect all related wiring and connectors and repair as necessary. If no problems were found with wiring and connectors, go to next step. If related wiring and connectors were repaired, perform TEST VER-2A .
- With engine idling, wiggle wiring harness from fuel injectors to PCM. If wiggling caused engine to misfire or stall, repair wiring harness as necessary where wiggling caused problem to appear. Perform TEST VER-2A . If wiggling did not cause misfire or stall, see INACTIVE TROUBLE CODE CONDITION . Test is complete. Perform TEST VER-2A .
- See INJECTOR TROUBLE CODE table.
INJECTOR TROUBLE CODE
| Trouble Code | Go To |
|---|---|
| INJECTOR NO. 1 CONTROL CIRCUIT | TC-21B |
| INJECTOR NO. 2 CONTROL CIRCUIT | TC-20A |
| INJECTOR NO. 3 CONTROL CIRCUIT | TC-19A |
| INJECTOR NO. 4 CONTROL CIRCUIT | TC-61A |
| INJECTOR NO. 5 CONTROL CIRCUIT | TC-69A |
| INJECTOR NO. 6 CONTROL CIRCUIT | TC-70A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
