1998 Eagle Talon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

No Trouble Code Complete Test

Check Technical Service Bulletins (TSBs) for any pertinent information. If a TSB exists, perform corrective procedure as instructed. If no TSB exists or if problem still exists, perform test TEST NTC-2A -TEST NTC-20A  in sequence until problem is found. See NO TROUBLE CODE TEST MENU  table.

NO TROUBLE CODE TEST MENU

Application Test
Checking Secondary Ignition & Timing NTC-2A 
Checking PCM Power & Ground Circuits NTC-3A 
Checking Engine Vacuum NTC-4A 
Checking Fuel Delivery NTC-5A 
Checking Coolant Sensor Calibration NTC-6A 
Checking Throttle Position Sensor Calibration NTC-7A 
Checking MAP Sensor Calibration NTC-8A 
Checking Minimum Idle Airflow NTC-9A 
Checking Oxygen Sensor Switching NTC-10A 
Checking Oxygen Sensor Heater NTC-11A 
Checking Idle Air Control Motor NTC-12A 
Checking Engine Mechanical Systems NTC-13A 
Checking Timing Belt Alignment NTC-14A 
Checking Evaporative Emission System NTC-17A 
Checking EGR System NTC-18A 
Checking Intake Air Temperature Sensor NTC-19A 
Checking Park/Neutral Position Switch NTC-20A 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.