BATTERY SPECIFICATIONS

Application & Group	Cold Cranking Amps	Amp Hr. Rating
Talon - Turbo (Group 86)	525	60

FLUID CAPACITIES

Application

⁽¹⁾ Quantity

Crankcase (Includes Filter) ⁽²⁾

4.6 Qts. (4.4L)

Cooling System ⁽³⁾

7.4 Qts. (7.0L)

Automatic Transaxle (Mopar ATF Plus Type 7176)

Drain & Refill

⁽⁴⁾

Dry Refill

7.1 Qts. (6.7L)

Manual Transaxle (SAE 75W-90/API GL-4)

2.4 Qts. (2.3L)

Transfer Case (SAE 75W-90/API GL-4)

All-Wheel Drive

1.1 Pts. (.51L)

Rear Differential (SAE 80W-90/API GL-5)

All-Wheel Drive

1.8 Pts. (.85L)

Power Steering Fluid (Mopar ATF Plus Type 7176)

1.9 Pts. (.9L)

⁽¹⁾	Approximate quantity listed.

⁽²⁾	Use an API engine oil that is certified for gasoline engines on all engines.

⁽³⁾	Quantity includes heater and coolant recovery tank.

⁽⁴⁾

Capacity is not available from manufacturer. Fill to COLD mark. Start engine and operate for 2 minutes. Shift through all gears and recheck fluid level with shift lever in Neutral. Adjust fluid level so fluid level is at COLD mark. Recheck fluid level with transaxle at normal operating temperature. Adjust fluid level so fluid level is at the HOT mark on dipstick.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Engine Controls - Specifications - Turbo: Capacities

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?